Here are his thoughts: Always use a kicker, allow enough flash time between coats to avoid die back or dull spots and allow at least 5 hrs before dew on horizontal surfaces... been there done that and I've got ten tee shirts... we color coat and then clear wet on wet and we buff whenever we want to after cure...Awlcraft 2000 paint holds up extremely well and

Keith _____ Live your life so that when you die, the preacher will not have to tell lies at your funeral. ----- Original Message ----- From: >> > > Bare brass, bronze and copper will oxidize in the open air. The color > ranges > from green through reddish brown to nearly black.

Keith _____ Live your life so that when you die, the preacher will not have to tell lies at your funeral. ----- Original Message ----- From: "Gilbert Sharell" > I have a 4 year old Zodiac,a Cadet 285s model and have had my floor > delaminate from the air tubes also. This is my second Zodiac with the same > problem.

We'll be running normally down the > waterway > at 7-8 kn, 2200-2400 RPM, when suddenly the engine will start surging and > faltering and die. After some frantic maneuvering to get to the side orf > the > channel and anchor, and doing the usual trouble shooting, we are able to > start the engine (Perkins 135) and proceed on.

I think that the 'list' format of T&T serves a need, if it didn't, like other internet ventures that are past their sell by date, it would wither and die. There is one very succesful forum with at least a small part of it given over to motor cruisers 'Cruisers Forum'.

I've purchased matching tap and die and use them to clean > up poor threads, or when I drill out the plugs for reuse. > > > > _______________________________________________ > http://lists.trawlering.com/mailman/listinfo/trawlers_lists.trawlering.com > > To unsubscribe or modify your subscription options (get password, change > email address, etc) go to: > http

jon_bondy wrote > I froze a flexible part and managed to tap it, but attempts to use a die > on a rod have failed, even when frozen. > > nop head: do you believe that print orientation is important when > printing threads?  That is, better with the rod horizontal or vertical? 

However, are you trying to log the *die* temperature? Or a temperature inside the case? -- Martin On 05/14/2016 09:07 AM, Simon Olvhammar via USRP-users wrote: > Hi, > > I'm searching for a way to log temperature sensor readings on the Ettus > X310 + UBX160/SBX120 in my software. > As far as I know there is only a sensor on the FPGA?

I tried splitting up the data into two testbenches of roughly 300 samples, but it still seems to die on the second test bench when it hits the 496th sample (my block that is).

In fact, the kid would die from heart disease brought on by Cholesterol of many, many hundreds long before any radiation impact was seen. Best, -John