All I know, is that I spend a gazillion hours cleaning my car, which, if parked in the wrong place, can often be referred to as the "guano mobile". Then there was the time one poor guy from the colony fried himself on the transformer outside the house, set the pole on fire and shut down the power to the whole neighborhood for hours.

Hi All! We just received two Newfs into rescue. Fosters needed. Both are very sweet dogs! They are both “a little” overweight. They get along with other dogs and cats. Thurston (7 1/2) the brown and white, is interested in them though. Vixy is the Landseer.

Shouting Congratulations all thevway from Raleigh N.C!! Loretta, You go girl!!

On Fri, Dec 26, 2008 at 3:35 PM, Kevin Gong wrote: > Hi Krishna, > > > > The sample project work well on mobile phone, but I haven't try to > route sound to headset.

Hello For our holding tank the following was advised by Covey Island Boatworks: Lavac pumps directly into top of holding tank Holding tank has an independent suction shore pump out pipe from the top of the tank to 2" above the bottom of the tank for vacuum pump outs At the bottom of the tank there is a 1-1/2" rigid outlet with a ball valve which leads directly

I remember one job where we were hoisting 55 gallon barrels of resin to the top of storage tanks. The hoist would do well, but as the barrel would get closer and closer to the top, it would slow down until about 5 feet from the top it couldn't get any higher... the diameter of the wraps was just too big.

If > the pump is above the tank you are asking it to suck the contents of the > tank all of the time even at start-up. Most pumps do better at pushing than > pulling. Also, you are asking for a dry start-up every time.

This way there is no need to carry an extra container of fuel, and all the fuel going to the engine's final filter must go through the racor's element first. I replace the filter, install the o-ring and cap, start the Tee Handle, then with the lid just slightly ajar, begin pumping fuel.

When you do F6 and get > the simple output: > > Top level object is a 3D object: > > Facets: 6 > > > CGAL has not been used at all. When it is you get: > > Top level object is a 3D object: > > Simple: yes > > Vertices: 8 > > Halfedges: 24 > > Edges: 12 > > Halffacets: 12 > > Facets: 6 > > Volumes: 2 Well, I am using version 2016.11.11 .

Q: Why is top-posting such a bad thing? A: Top-posting. Q: What is the most annoying thing in e-mail?