we have USRP B200.All I want to do is to transmit a specific signal without distorting phase.Say, I want to transmit the cosine wave, which have center frequency fc = 3Mhz and phase is 60 degree(i.e. y = cos(2*pi*3e6*t + pi/3) ) through the Tx/Rx channel in USRP B200.But, I heard that there is a consistent phase offset after tuning.

I wasn't re-tuning the Fc anywhere, I was just dropping the sample rate from 120MHz down to something I could handle. Right now I am not touching the CORDIC modifications at all. Are you trying to change the samplerate at runtime after starting the stream?

They'll be more accurate, for reasons that you can read > about in 15 years of FCS proceedings, and they'll be more reliable because > of 15 years of electronics evolution and manufacturing improvements. Good points. Very good points. Thanks for pointing it out. Kind of obvious, but you need to recall the obvious at times.

. > http://thirdpartyoffers.juno.com/TGL2141/fc/Ioyw6i3l8Op2dKMrmSXhHChrYqlJXFP6LXoDtx9dtYTJzdmc3WCvct/ > > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. >

MHz signal that > excites the CBT, as explained in my FCS paper in the early > 90's. > > I don't understand how you got worse phase noise with a DRO > than a VCO, unless you used a narrow loop bandwidth for the > DRO and a wide loop bandwidth for the VCO. Same basic loop for both..

I'm inclined to say I stand corrected, BUT: (i) as Mark noted, the datasheet link points to the datasheet for Vishay FC Series HF thin-film resistors [which are really excellent low-reactance T/F resistors, if you need any]; (ii) I cannot find any reference to PC caps on the Vishay/BC web site; and (iii) other distributors do not list this cap (or any Vishay

>The google url is >https://patentimages.storage.googleapis.com/53/fc/f0/26d83e477e999a/US3810234.pdf >Mike Monett

I don't think we care about glitches and and if the VXCO is stable but as soon as it does locj the pulse going to pin the 4520's pin-10 will be 1024 times longer than the the period of the signal at pin-9 Again, pins 10 and 9 are the two inputs to an AND gate (after pin-10 is inverted) On Mon, Mar 25, 2013 at 2:04 PM, Bob Camp wrote: > Hi >

Cold north winds did not deter many birders from venturing down to Thickson's Woods on Friday May 10, where over the AM hours they found a number of wonderful areas to stand and enjoy some good birding.

. >> >> BR, >> nanang >> >> >> On Wed, Aug 10, 2016 at 4:20 AM, Alexei Gradinari >> wrote: >> >>> Hello, >>> >>> The function init_sock at pjlib-util/src/pjlib-util/resolver.c >>> should check if the IPv6 is available instead of return an error. >>> >>> Regards, >>> Alexei >>> >>> >>> _______________________________________________ >>> Visit