for locking to GPSDO 10 MHz > references > > > Soundcards for USB are poor at best. > > I have a set of PCI cards that were previously made by EMU and > they accept > external reference input.

But I will look into the practicality of implementing a differential line for the long run of 10 MHz cable.  However, I will still need to implement traditional coaxial isolated 10 MHz outputs.

. > > Regards > > Paul > > WB8TSL > > > > > > On Fri, Nov 8, 2013 at 3:27 PM, wrote: > > > >> Hi, > >> > >> I used to have notes on how to select which output frequency the EG&G > >> RFS-10-7 provides but I can't find them! > >> > >> It can be 5 or 10 Mhz. > >> > >> Does anybody know where the selection is made?

TONIGHT, Sat, Oct 3 and get a special priced $10 RUSH ticket for C P Stancich's new play SHERLOCK HOLMES AND THE DOOM OF DEVILSMOOR at the Lakewood Playhouse 5729 Lakewood Towne Center BLVD. SW off I-5 at exit 125. Plenteous parking (free) and great bars and restaurants close. This is a Northwest premiere by a published Gig Harbor playwright.

BTW, I've installed gnu make for Windows and am using a makefile to create about 20 stls from around 10 scad files and it works well. I'm happy to share my makefile syntax but it's nothing complex. BTW, I find builds are faster on Linux and don't bring the machine to its knees in the same way. I have no idea why.

> -----Original Message----- > > > > Lastly, my customer, the system designer, would now like to be able to add a switch function to the > 10 MHz distribution. I will have to check and see if switching of bias current to these two-stage > transistor amp circuits can accomplish this function.

life speed wrote: > From: Bruce Griffiths > Subject: Re: [time-nuts] Advice on 10 MHz isolation/distribution > > Its easy to calculate a lower bound to the amplifier phase noise floor > from the signal level at the output and the amplifier output noise due > to feedback resistors together with the amplifier input voltage and > current

First, here is the system setup: - Intel X710 dual 10 Gb/s SFP+ NIC - 2x SFP+ direct attach copper cables - X310 (revision 4) - 2x UBX-160 (both v1 boards) - UHD_3.13.1.HEAD-0-ga0a71d10 - Ubuntu 16.04 When I updated the firmware of the radio I noted that port 0 was not showing up as having a link (per ethtool).

Opt PCB's for the HP 5087A: > .... > > Qty. 11 5087-60012 (10 MHz Amplfiers) > > Good luck.