Tina Green Westport Sent from my iPhone Begin forwarded message: > From: ACKBIRD@aol.com > Date: November 10, 2012, 11:07:06 AM EST > To: massbird@world.std.com > Subject: [MASSBIRD] 11/10/12 2 Lapwings on Nantucket YES!!!

Etching primers generally go on really thinly (1mil or even at .5 mil). They are best applied as evenly as possible and usually show the substrate thru the coating. Then two coats of epoxy and then your anti-fouling. All with proper dry times. If the flash or etching primer is too thick it will fail. Good luck.

The original MIL spec was 2104B which is now 2104F or maybe "G"... In any case, the oils must also meet CF2 designation and many now will say CF2/CF4 which is fine. Picking an oil weight is a compromise between cold weather starting and operation.

Also approved are SAE API service class CC engine oil and MIL-L-2104B. Oil viscosity: Note. Multi viscosity oils (i.e. 10W-40, etc.) are not recommended and should not be used in Twin Disc Marine Transmissions. Weights: (Temps refer to sump oil temp and oil in heat exchanger.)

Select3 uses a mil-spec (for what that's worth) additive called Lubribor. Select3 is made by Hammonds, which is the same company that makes Biobor, the diesel fuel bug killer, which we also use. I don't know if the Select3 is helping or not.

The DC jack coordinates are also offset for the width of an 1/8” end mil. > > https://dl.dropboxusercontent.com/u/49570443/b200_hammond_1455L1601.pdf > https://dl.dropboxusercontent.com/u/49570443/b200_hammond_1455L1601_a.jpg > https://dl.dropboxusercontent.com/u/49570443/b200_hammond_1455L1601_b.jpg > > Lou, > KD4HSO > > > > ____________________________

If you need more than a couple of one type, pick a > standard and an extended temperature range model, and perhaps a mil spec > one too.

If you make this, please use connector as follows: Bendix PT06A-14-18P1005 Power Connector for the HP5061A, I have some complete it but I think please order this MIL spec. connector from some parts dealer in USA that parts number as following: Cannon MS3106A-18-22SW and accessories Standby power supply HP5089A that very hard to find depend on discontinued products

> Is this only for mil-spec stuff or for regular laboratory > test equipment too? > > /tvb > > > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com To unsubscribe, > go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. >

My payload on ISS (SCaN Testbed) had a >> MIL-STD-1553 connection and a unidirectional Ethernet connection (out of >> payload only).