Terrypin wrote > Starting with Top, I chose these, all accompanied by Ctrl+Shift with my > left > hand: > > 8 = Top, 2 = Bottom, 4 = Left, 6 = Right, 1 = Front, 9 = Back I gather it works well for you. The reason I suggested my way was that 9 and 3 are also (Pg)up and (Pg)down. That is, if I had a numpad. -- Sent from: http://forum.openscad.org/

It did, but not at the top of the hour! The second hand went into rapid mode some time after 1:05 UTC and finished at about 1:10 UTC. Maybe it enabled the WWVB receiver at the top of the hour and held off the high speed hands movement until after it sync'd? -- newell N5TNL

You could always drill a hole large enough in diameter (from the top) to accommodate a brass, bronze, stainless steel or fiberglass pipe/tube whose ID can allow the size fastener that you want to use to pass through it. Epoxy that to the inside of the bottom layer and flush to the top of the deck. Smooth off and paint. Drill for through bolts.

_1G=1 BUILD_10G=1 SFP0_1GBE=1 SFP1_10GBE=1 X300=1" DEFAULT_RFNOC_IMAGE_CORE_FILE=x300_rfnoc_image_core.v DEFAULT_EDGE_FILE=/home/maurizio.stefani/prove/vhd/uhd-master/uhd-master/fpga/usrp3/top/x300/x300_static_router.hex make[1]: Entering directory '/home/maurizio.stefani/prove/vhd/uhd-master/uhd-master/fpga/usrp3/top/x300' BUILDER: Checking tools... * GNU bash

so that the boxes could nest on top of each other.

6156] failed synthesizing module 'bus_int' >> [/home/sp/Documents/uhd-4.1.0.5/fpga/usrp3/top/x300/bus_int.v:9] >> ERROR: [Synth 8-6156] failed synthesizing module 'x300_core' >> [/home/sp/Documents/uhd-4.1.0.5/fpga/usrp3/top/x300/x300_core.v:9] >> ERROR: [Synth 8-6156] failed synthesizing module 'x300' >> [/home/sp/Documents/uhd-4.1.0.5/fpga/usrp3/top/x300/x300

. - David Lightman, played by Matthew Broderick was a young computer whiz kid who accidentally connects into a top-secret super-computer named War Operation Planned Response (WOPR), pronounced 'whopper'.

While the memories of the places will never die, the friendships are forever. My friends, so is it with this Trawler World List. It isn't the technical issues or cruising tales that are important. It is the friendship we have been given by the association we enjoy. It is me not wanting to burden you with this event.

Is it on a desk top PC or on a laptop in a rolling boat in salt water. Do we turn the disks off gets into start/stop cycles. Again a manufacturer provides a spec on start/stop cycles. I just had a disk fail this year after continuous use for 10 years, aside from moving time to other locations.

. > > You could try one of the binaries from the examples supplied with uhd, > for example rx_samples_to_udp,or _to_file and see if it runs without a > GUI on top for the desired amount of time (warning: 15 minutes of > 8Msam/s will be around 29 GB, so make sure you're not filling up your > SSD inadvertently). > > All the best, > Marcus > > On Sat, May 3,