For me, I am lazy, and I started out with top posting decades ago.

Visit our website at http://www.cruisingfrancesca.org/ for details. Visit our website at: http://www.cruisingfrancesca.org/

Comment: You can check the West Marine website. They display plotter models and and cartridge(s) accepted....I'd also check the C-MAP website... Rob Brueckner Hatteras Yachtfisherman

I use a screwdriver inserted into the U-shaped handle at the top of the center spindle. Be careful not to scratch the lip at the top or you will have a leaker going forward. Regards, Randy Pickelmann Morning Star lying Ottawa www.CruisingMorningStar.com

I just picked up the last one in Orange Park, Florida. 15.00 +tax not bad Ciao, Capt Joe **************************************See AOL's top rated recipes (http://food.aol.com/top-rated-recipes?NCID=aoltop00030000000004)

Lee **************************************See AOL's top rated recipes (http://food.aol.com/top-rated-recipes?NCID=aoltop00030000000004)

The Trout Brook Say's Phoebe continues as of 2:00 on top of the barn with the red roof. Was also seen on top of the tree next to the barn with the two white garage doors. Charlie Plimpton Sent from my iPhone

Starting with Top, I chose these, all accompanied by Ctrl+Shift with my left hand: 8 = Top, 2 = Bottom, 4 = Left, 6 = Right, 1 = Front, 9 = Back -- Sent from: http://forum.openscad.org/

Peggy wrote: You're overlooking one minor little detail: his tank discharge fitting is on the top of the tank, with a pickup tube inside the tank to the bottom. So the pump has to run dry long enough to pull contents out of the top of the tank no matter where it's installed.

. > > Now imagine the top object in the same manner but having a completely > different shape. > > Keep each of them centered on the X and Y axis and separated on the Z axis. > > A single object can be created by wrapping these two top and bottom > objects within hull(). > > Works fine ... except the shape of the top and bottom of the final object > is not the