His quote was around $4k if I did all the prep. I have done alot of painting in the commercial construction trade - alot of spraying with 1 part paints, and alot of rolling with 1 and 2 part paints.

All four were replaced and they have been working fine. The two older 732A's have thermistor values in the 3k-4k range. The newer unit (based on the newer heater rev) is around 4.25K. All three had their potentiometers changed on the regulator and pre-regulator boards. The datecodes on all appeared to be from 1985.

All went well and we are ready to leave on our journey Saturday 1/5/00. We will be doing email off the cell phone and on landlines when possible. It will be difficult to keep up with all the Trawler network. George, I left my Trawlerworld instructions back home. Please take me off the mail list for a while. Thank you.

All I get is hard zeros, yet with the exact same hardware setup and signal, but using 16 bits, I get data. I can verify the correct green leds come on, so it is not the subdev spec or number of channels, I dont think. I have tried all sorts of stuff, including loading the latest (as of friday) code from git.

Aug 11th $44 for party bus all you can drink and VIP ticket... Who's coming with me, and lay, and someone lay is bringing, and doc steve... I feel the need... Speedro

https://allalongtheriverwalk.org/general-information/ (The Map of the route is on the website)

Sounds like an excuse to me, especially as their website suggests variable pitch distribution is standard on all their performance propellers. Can anyone please enlighten me as to what variable pitch distribution is, and whether it has to be custom to each vessel, and whether it could really make a difference equivalent to removing 1.5" of pitch?

A few had manged to get into the pintels - that's all. Like I said, I use Penaten Cream. So, why don't you relocate to iceberg country already George of Scaramouche, Lake Ontario, Canada P.s. I don't polish my shiny three-bladed thing on the end of the shaft. So it has taken on a smooth greenish grayish colour.

They are quiet, too. 2) If I need even more pressure I can run two pumps in parallel (handy when there are lots of people on board). 3) Best of all, I usually just run a single pump at a time.

Bolt it all to a plywood subpanel, wire it up with the #10 to the input of the breaker panel and the duplex outlets fed through the 15 amp breakers and you have an instant source of power on the dock. Choice 2 is a bit cheekier, but it's what I did. Go to Home Despot and buy the best power bar they have. Make sure it has a 15 amp breaker on the input.