Example STL files would help. Sometimes towards the end of a print with
details (think of the peaks of mountain ranges when printing a topo map)
each layer takes so little time to print that the plastic does not have
enough time to cool between layers. Some slicers let you specify a
minimum layer time, and will loiter to give the plastic time to cool.
It does not take any power to print 3D objects. The gCode has been
calculated and all the PC is doing is spewing bytes out to the printer.
This discussion group is mostly for CAD with OpenSCAD: you might get
better responses from a Lulzbot Taz forum.
Good luck!
Jon
On 12/26/2021 3:32 PM, charles meyer wrote:
Has anyone experienced detailed printing problems with High Resolution
files using Lulzbot Taz 6 printer with Cura 3.6.31 software?
It prints regular files OK but after a new toolhead was installed and
the toolhard was bored out to be a little larger (wider) with a drill
so the filament could be changed it has problem printing in detail.
I checked with Luilzbot and they say our PC (running Windows 10) has
plenty of power to print 3D prints.
It prints most of the object but toward the end it loses detail and
the object is smeared.
Thank you.
OpenSCAD mailing list
To unsubscribe send an email todiscuss-leave@lists.openscad.org
Example STL files would help. Sometimes towards the end of a print with
details (think of the peaks of mountain ranges when printing a topo map)
each layer takes so little time to print that the plastic does not have
enough time to cool between layers. Some slicers let you specify a
minimum layer time, and will loiter to give the plastic time to cool.
It does not take any power to print 3D objects. The gCode has been
calculated and all the PC is doing is spewing bytes out to the printer.
This discussion group is mostly for CAD with OpenSCAD: you might get
better responses from a Lulzbot Taz forum.
Good luck!
Jon
On 12/26/2021 3:32 PM, charles meyer wrote:
> Has anyone experienced detailed printing problems with High Resolution
> files using Lulzbot Taz 6 printer with Cura 3.6.31 software?
>
> It prints regular files OK but after a new toolhead was installed and
> the toolhard was bored out to be a little larger (wider) with a drill
> so the filament could be changed it has problem printing in detail.
>
> I checked with Luilzbot and they say our PC (running Windows 10) has
> plenty of power to print 3D prints.
>
> It prints most of the object but toward the end it loses detail and
> the object is smeared.
>
> Thank you.
>
>
>
> _______________________________________________
> OpenSCAD mailing list
> To unsubscribe send an email todiscuss-leave@lists.openscad.org
