Hi all;
I'm running LH on laptop with Win XP, a T-Bolt with Trimble Bullet II-HE, 25'
RG-6. LH continually says after 24+ hours "no usable sats" yet T-Bolt Monitor
program shows everything operating properly. AMU on LH <1.4 one only one PRN no
others have any reading. On T-bolt Monitor AMUs between ~5 to 14.3. LH boots
up and seems to find the T-BOLT. What am I doing wrong?
Rich W9ENG
Rich,
I might guess the laptop is putting the rs 232 port to sleep since the
system isn't being touched. A pure guess. But I run LH on a win XP laptop
and seem to recall that happened to me also.
Do not recall what I did to fix it quite a while ago. Think it was down in
the BIOS and various power savings at higher levels.
Good luck
Paul
WB8TSL
On Tue, Dec 27, 2022 at 8:34 AM R&M Putz via time-nuts <
time-nuts@lists.febo.com> wrote:
Hi all;
I'm running LH on laptop with Win XP, a T-Bolt with Trimble Bullet II-HE,
25'
RG-6. LH continually says after 24+ hours "no usable sats" yet T-Bolt
Monitor
program shows everything operating properly. AMU on LH <1.4 one only one
PRN no
others have any reading. On T-bolt Monitor AMUs between ~5 to 14.3. LH
boots
up and seems to find the T-BOLT. What am I doing wrong?
Rich W9ENG
time-nuts mailing list -- time-nuts@lists.febo.com
To unsubscribe send an email to time-nuts-leave@lists.febo.com