OK its a reverse mini 9 pin. It will be expensive I suspect as its mil. Or just find some pins stick them in with wires for temp. If the cover can be removed potentially much more insight can be gained. Given at this point they are worthless. No harm or foul in diving in. Potentially you can at least find ground on the pins. Regards Paul WB8TSL On Tue, May 12, 2020 at 1:04 PM <brucekareen@aol.com> wrote: > Here are a couple of pictures of these curious oscillators. There appears > to be a threaded thermometer well in the front and a frequency adjustment > in the rear under a cap screw. As there are no mounting holes to secure > these, I assume they were held in a clamping arrangement. > > Bruce, KG6OJI >

On 5/12/20 10:18 AM, paul swed wrote: > OK its a reverse mini 9 pin. It will be expensive I suspect as its mil. > Or just find some pins stick them in with wires for temp. Is it a MicroD? There are some inexpensive plastic connectors that are compatible (I can't remember the part number, but if they are MicroD, I'll track it down). You might check Omnetics, too. > If the cover can be removed potentially much more insight can be gained. > Given at this point they are worthless. No harm or foul in diving in. > Potentially you can at least find ground on the pins. > Regards > Paul > WB8TSL > > On Tue, May 12, 2020 at 1:04 PM <brucekareen@aol.com> wrote: > >> Here are a couple of pictures of these curious oscillators. There appears >> to be a threaded thermometer well in the front and a frequency adjustment >> in the rear under a cap screw. As there are no mounting holes to secure >> these, I assume they were held in a clamping arrangement. >> >> Bruce, KG6OJI >> > _______________________________________________ > time-nuts mailing list -- time-nuts@lists.febo.com > To unsubscribe, go to http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com > and follow the instructions there. >