Hi
I believe that if you *do* find the HP software, it will only run on some odd combination of old OS and (maybe) old hardware.
Since all the internals are accessible via SCPI commands, a terminal program hooked to the serial port and a bit of typing will show you what I believe you are looking for.
The details of all the commands are in here:
https://xdevs.com/doc/HP_Agilent_Keysight/HP 58503A, 59551A Operating & Programming & Supplemental Note & Guide.pdf <https://xdevs.com/doc/HP_Agilent_Keysight/HP%2058503A,%2059551A%20Operating%20&%20Programming%20&%20Supplemental%20Note%20&%20Guide.pdf>
On page 3-3 it suggests that simply typing:
:SYSTEM:STATUS?
Will get you the info you are looking for. A quick read of the manual suggests that the HP software simply sends that string over and over again. Yes, it was a quick read and I could easily have missed something.
Bob
> On Aug 26, 2024, at 3:47 PM, Mike Burroughs via time-nuts <time-nuts@lists.febo.com> wrote:
>
> Hello,
> I am hoping someone can help me out with getting ahold of the software for
> an agilent 58503a. I am trying to get the interface software to verify the
> lock with the signal. I appreciate any help you can give me.
>
> Thank you,
>
> Mike Burroughs
> *Division Manager - Seattle*
> Office Seattle: +1 (425)821-0902
> www.microprecision.com
>
> *Beginning on May 6, 2024 Micro Precision will be *going* paperless with
> our calibration certificates. If you have questions or concerns please
> reach **to terri.brooks@microprecision.com
> <terri.brooks@microprecision.com> and/or mikeb@microprecision.com
> <mikeb@microprecision.com>**.*
> _______________________________________________
> time-nuts mailing list -- time-nuts@lists.febo.com
> To unsubscribe send an email to time-nuts-leave@lists.febo.com
