trawlers@lists.trawlering.com

TRAWLERS & TRAWLERING LIST

View all threads

Fw: Fuel Polishing Question

TW
Tom Wadsworth
Fri, Jan 2, 2009 4:29 PM

I need to add a fuel polishing circuit.
Can anyone comment on a 24 volt pump they have had good luck with?
Thanks
Tom
Mai Pehn Rai

I need to add a fuel polishing circuit. Can anyone comment on a 24 volt pump they have had good luck with? Thanks Tom Mai Pehn Rai
SH
Scott H.E. Welch
Mon, Jan 5, 2009 5:45 PM

Can anyone comment on a 24 volt pump they have had good luck with?

Most folks seem to go with small engine-type fuel pumps (e.g. Walbro). With
two 1000 gallon (4000 litre) tanks, that was not going to cut it for me. I
went with a centrifugal pump, a Groco CP-20. This is rated at about 10 GPM,
in practice I find it does almost exactly 10 litres a minute through parallel
Racor 1000 filters. It's controlled by an 30 minute Intermatic timer switch,
allowing me to transfer and/or polish up to 300 litres at a time.

The centrifugal pump must be lower than the tank, but I've had excellent
results so far. For more details see http://www.islandeagle.net/systems/fuel

Scott Welch

tbw@comcast.net writes: >Can anyone comment on a 24 volt pump they have had good luck with? Most folks seem to go with small engine-type fuel pumps (e.g. Walbro). With two 1000 gallon (4000 litre) tanks, that was not going to cut it for me. I went with a centrifugal pump, a Groco CP-20. This is rated at about 10 GPM, in practice I find it does almost exactly 10 litres a minute through parallel Racor 1000 filters. It's controlled by an 30 minute Intermatic timer switch, allowing me to transfer and/or polish up to 300 litres at a time. The centrifugal pump must be lower than the tank, but I've had excellent results so far. For more details see http://www.islandeagle.net/systems/fuel Scott Welch