If you'll put an arduino in as a controller, Makerrplot is a really nice interface, and really cost effective and easy to use. Can also be used on 'net devices and rs232. Robot Basic will do rs232 and 'net and is free. Don paul swed > Have the eval license up and operating with the NI simple LED test. It > works. > I can easily see how you could use this to create a nice GUI for some sort > of control project. > Regards > Paul > WB8TSL > > On Sun, Jun 21, 2015 at 6:09 PM, Jim Lux <jimlux@earthlink.net> wrote: > >> On 6/21/15 11:28 AM, Don Latham wrote: >> >>> Just for fun, went to the site. $149 for basic, but by the time I added >>> all >>> the toolboxes I thought (!) I needed, I was over $750. sigh. >>> Don >>> >>> >> Hence the popularity of the student license (or Octave) >> >> >> _______________________________________________ >> time-nuts mailing list -- time-nuts@febo.com >> To unsubscribe, go to >> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >> and follow the instructions there. >> > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > > -- "Noli sinere nothos te opprimere" Dr. Don Latham AJ7LL Six Mile Systems LLC 17850 Six Mile Road Huson, MT, 59846 mail: POBox 404 Frenchtown MT 59834-0404 VOX 406-626-4304 CEL 406-241-5093 Skype: buffler2 www.lightningforensics.com www.sixmilesystems.com