I use anchor pins in some boats--that is what the hack saw, 4# sledge hammer, 36" crow bar, battery power sawzall and cut off wheel (in my case 110 V powered-today would be battery powered (combo 4" disc sander/grinder, cut off wheel, wire brush--Porter Cable). Regards, Bob Austin

Bob said: I use anchor pins in some boats--that is what the hack saw, 4# sledge hammer, Scott says: Well then I'm all set, because I have the Dewalt 4" disk grinder which should make short work of it! Building experience one mistake at a time :) Scott Bulger, Alanui, N40II, Seattle WA

Scott: Good luck on your voyage, venture and new step in our life. I have enjoyed following your postings! Safe journeys ahead! Craig ----- Original Message ----- From: "Scott Bulger" <scottebulger@gmail.com> To: "'Passagemaking Under Power List'" <passagemaking-under-power@lists.samurai.com>; "'Ron Rogers'" <rcrogers6@kennett.net> Sent: Friday, August 17, 2007 9:33 PM Subject: Re: [PUP] Anchor pin > Bob said: I use anchor pins in some boats--that is what the hack saw, 4# > sledge hammer, > > Scott says: Well then I'm all set, because I have the Dewalt 4" disk > grinder which should make short work of it! > > Building experience one mistake at a time :) > > Scott Bulger, Alanui, N40II, Seattle WA > _______________________________________________ > http://lists.samurai.com/mailman/listinfo/passagemaking-under-power > > To unsubscribe send email to > passagemaking-under-power-request@lists.samurai.com with the word > UNSUBSCRIBE and nothing else in the subject or body of the message. > > Passagemaking Under Power and PUP are trademarks of Water World > Productions, formerly known as Trawler World Productions.