I'm looking for two more receivers to implement "Pair and a spare" redundancy for our engineering lab and production.
Are these below compatible with Lady Heather?
Any thoughts as to overall quality etc?
Any other suggestions?
--
David VanHorn
Lead Hardware Engineer
Backcountry Access, Inc.
2820 Wilderness Pl, Unit H
Boulder, CO 80301 USA
phone: 303-417-1345 x110
email: david.vanhorn@backcountryaccess.commailto:david.vanhorn@backcountryaccess.com
We have used the first one with good results two and three are probably the same and on closer look I would stay away from them. The ublox is not even a timing receiver I have done stuff like that on a 2 by 2 inch board calling it a GPS PLL. Number four most likely like 2 and 3. Get the first one, also best price.
Bert Kehren
In a message dated 7/23/2018 3:03:40 PM Eastern Standard Time, david.vanhorn@backcountryaccess.com writes:
I'm looking for two more receivers to implement "Pair and a spare" redundancy for our engineering lab and production.
Are these below compatible with Lady Heather?
Any thoughts as to overall quality etc?
Any other suggestions?
--
David VanHorn
Lead Hardware Engineer
Backcountry Access, Inc.
2820 Wilderness Pl, Unit H
Boulder, CO 80301 USA
phone: 303-417-1345 x110
email: david.vanhorn@backcountryaccess.commailto:david.vanhorn@backcountryaccess.com
time-nuts mailing list -- time-nuts@lists.febo.com
To unsubscribe, go to http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com
and follow the instructions there.
I'm looking for two more receivers to implement "Pair and a spare"
redundancy for our engineering lab and production.
Are these below compatible with Lady Heather?
Any thoughts as to overall quality etc?
Any other suggestions?
[]
David VanHorn
Lead Hardware Engineer
---=============
David,
You might look at the Leo Bodnar boxes if you want quality and support in a
modern unit:
NTP server with a PPS/1 MHz/10 MHz output:
http://www.leobodnar.com/shop/index.php?main_page=product_info&products_id=272
450 Hz - 800 MHz GPSDO with either 1 or two outputs:
http://www.leobodnar.com/shop/index.php?main_page=product_info&products_id=234
http://www.leobodnar.com/shop/index.php?main_page=product_info&products_id=301
I'm using all three here and there have been no problems.
SatSignal Software - Quality software written to your requirements
Web: http://www.satsignal.eu
Email: david-taylor@blueyonder.co.uk
Twitter: @gm8arv