> Hello > > I have an USRP2 device. I configure my computer to connect with USRP2 > hardware as in > http://www.mathworks.com/support/solutions/en/data/1-D2KBPZ/index.html?product=CB&solution=1-D2KBPZ > > and obtain firmware for my USRP2 as in > http://www.mathworks.com/support/solutions/en/data/1-CUN7JZ/index.html?product=ML&solution=1-CUN7JZ > > However, when I try the demo "commusrp2", and set the ip address of USRP2 > block as "192.168.10.2" or "192.168.10.255" , my pc's address is > "192.168.10.1" as the manual said: > "Embedded MATLAB Runtime Error: Board did not reply to a host query or > configuration. Cannot run simulation. Please ensure you have a connection > by > opening the block mask and examining the Hardware section." Have you turned off your firewall ? I use Win7 and turned it off for the public networks. When you put the SD Card in the LED s D and F glow ? I had problems with burning the SD Card with Win7. My colleague burned it with Ubuntu.... Greetz Vlad > > How can I solve this problem? > > Thanks a lot. -- Empfehlen Sie GMX DSL Ihren Freunden und Bekannten und wir belohnen Sie mit bis zu 50,- Euro! https://freundschaftswerbung.gmx.de