In a message dated 12/11/2007 03:11:24 Pacific Standard Time, bruce.griffiths@xtra.co.nz writes: >To check correct operation vary the Fury EFC output from 0 to 5V with >the desired offset at U3 +ve input. >Bruce Hi gents, this can be done manually with the command serv:coarsedac [0,255] bye, Said **************************************See AOL's top rated recipes (http://food.aol.com/top-rated-recipes?NCID=aoltop00030000000004)

This was the story at Slashdot today. http://hardware.slashdot.org/article.pl?sid=07/12/11/0517234 I bet some of our guys (febo, leapsecond) are seeing an increased volume as well. -George

Probably picked up a few new list members as well... O:-) de KC6OOM/5 rvassar@rob-vassar.com robert.vassar@sun.com On Dec 11, 2007, at 11:42 AM, xaos@darksmile.net wrote: > This was the story at Slashdot today. > > http://hardware.slashdot.org/article.pl?sid=07/12/11/0517234 > > I bet some of our guys (febo, leapsecond) are seeing an increased > volume as well. > > -George > > > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/ > time-nuts > and follow the instructions there.

Keith 

The article is also referenced at Make Magazine: http://blog.makezine.com/archive/2007/12/time_hackers.html I highly recommend this magazine for all the tinkerers out there. Keith -----Original Message----- From: time-nuts-bounces@febo.com [mailto:time-nuts-bounces@febo.com] On Behalf Of xaos@darksmile.net Sent: Tuesday, December 11, 2007 9:43 AM To: Discussion of precise time and frequency measurement Subject: [time-nuts] We are in Slashdot This was the story at Slashdot today. http://hardware.slashdot.org/article.pl?sid=07/12/11/0517234 I bet some of our guys (febo, leapsecond) are seeing an increased volume as well. -George _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.