All of the top Z values would have been calculated using the same numbers, as would all of the bottom Z values. Those top Z values would either all be the same as the bottom Z values of the next layer, or would all be different. In either case, you're OK.

 module top(){  cylinder (d1=radius2*2,d2= radius1*2,$fn=6, h=60);  }  hull(){  translate([0,0,heightbase])  top();  base();  } On 24/11/2024 15:35, FPA via Discuss wrote: > > Hello, > > as part of my learning, I want to make a round screw container (see > image attached). > > It supposed to be a round container with a middle section (small > circle

I did notice that the resistors R112 and R113 near P2 on > the top board seem odd. R112 looks to be soldered very poorly and R113 is > missing completely! Does anyone have an opened up unit or the top board > loose so they can let me know what R112 and R113 are supposed to look > like? The schematic I have does not show R113.

I printed a knob to go on > my audio amp and my first version had a domed top like shown and I > scratched that and went back to flat after I felt the model in hand. > > The other thing that does NOT look great is a roundover printed upside > down. > > Hi Adrian, you half answered your own question to me, and nop head gave > the top half answer, wrt adaptive

Of course, you do not need a flat, but there are advantages to at least rounding off the top edge. If left pointed, then you will need to adjust the mating profile in the real world. You can use offset to get the profile of the fitting, with a negative delta value for the radius of router to get the shape around the pointy top.

"; // [Top, Bottom]/* [Stock] */stockorigin = "Center"; // [Lower-Left, Center-Left, Top-Left, Center]/* [Stock] */retractheight = 9; opengcodefile(Gcode_filename);opendxffile(DXF_filename); difference() {setupstock(stocklength, stockwidth, stockthickness, zeroheight, stockorigin); movetosafez(); toolchange(squaretoolno,speed * square_ratio); begintoolpath(0,0,0.25

Dear All, As promised, the draft by-laws for the new corporation are now on the Song-Yuan website. Please let me know your thoughts and suggestions. Yours truly, Michael

See our website, or join us on Facebook! -------------------------------------------------------------------------------- ////////////////////////////////////////////////////////////

I have searched Google, satellite maps, Bloomfield websites, Seabury Retirement site, and cannot find mention of this reservoir. Directions? Thanks. Susanne Shrader birdgirrl@comcast.net

Not on my website Thanks Contact Rudy Nelson nelsontrawlers.com (252) 728-6278