First of all your engine is not going to die if your alternator quits it's only going to die if your batteries go stone dead. Most mechanical engines use an electric control to turn on the injection pump that requires power to run so they will die if your battery goes stone dead also.

I'd rather see if it works OK before investing in a new one > first... and that connector is a bear. > > > -- > Dave Emery N1PRE/AE, die@dieconsulting.com DIE Consulting, Weston, Mass 02493 > "An empty zombie mind with a forlorn barely readable weatherbeaten > 'For Rent' sign still vainly flapping outside on the weed encrusted pole - in > celebration of

I remember I had to fix this PLL in my box before the > receiver in that box would lock up... initially the PLL wasn't locked, > but the 16.368 VCXO output WAS present - so for that receiver it has to > be pretty close to right on to work. > > > -- > Dave Emery N1PRE/AE, die@dieconsulting.com DIE Consulting, Weston, Mass 02493 > "An empty zombie mind with

Emery" <die@dieconsulting.com> wrote: > On Wed, Jul 10, 2013 at 02:42:19PM -0700, J.

Emery <die@dieconsulting.com> wrote: > On Fri, Aug 15, 2014 at 03:09:23PM -0400, paul swed wrote: > > > I had discounted it because of the lack of info and totally unclear how > to > > get rid of the FSK. MSK is FSK just with a very narrow shift. Also the > > effects of the fsk on the carrier.

. > > > -- > Dave Emery N1PRE/AE, die@dieconsulting.com DIE Consulting, Weston, > Mass 02493 > "An empty zombie mind with a forlorn barely readable weatherbeaten > 'For Rent' sign still vainly flapping outside on the weed encrusted pole - > in > celebration of what could have been, but wasn't and is not to be now > either." > > ____________________________

First pass would be to pull the plastic off of a couple of bad ones and get some pictures of the die. After that, trace them back and see if they are Brand A or Brand B. Next, do the same for a good one (or two) and see if the die trace to the same manufacturer.

That design is a single piece and would be simpler to manufacture (one piece, by CNC and die-sink EDM.. But requires die-sink EDM. *Could* it be done with CNC? The smallest features of the characters are about 0.1 mm, and I doubt a CNC bit that thin is possible. Is there such as a "needle sink" EDM that's used to do very fine engravings?

Blank Family Foundation to Support Innovation and Entrepreneurship Spelman College today announced a $10 million grant from The Arthur M. Blank Family Foundation to support an on-campus creative hub for young entrepreneurs and innovators. The funding will establish the Arthur M. Blank Innovation Lab.

Email Your Name to RSVP: tamsugah@aol.com Join three published women writers and editors to get helpful publication information, encouragement, support, creative ideas and inspiration to write your own book this year!