[USRP-users] SFP port1 of USRP N310 does not work
Marcus D. Leech
patchvonbraun at gmail.com
Wed Jul 29 08:42:10 EDT 2020
On 07/29/2020 08:14 AM, Heng Zhang via USRP-users wrote:
> Dear community,
> I follow this guide
> and now I can connect to N310 by RJ45 port. And I also can connect to
> SFP port0. However, when I try to use SFP port1, it does not work. I
> found that the green LED above SFP port 1 does not even illuminate
> after connecting the PC to it. The network interface configuration of
> PC is shown as follows
> enp1s0 Link encap:Ethernet HWaddr d4:5d:64:9c:d1:86
> inet addr:192.168.20.1 Bcast:192.168.20.255 Mask:255.255.255.0
> inet6 addr: fe80::3ac5:ee40:457b:3554/64 Scope:Link
> UP BROADCAST RUNNING MULTICAST MTU:9000 Metric:1
> RX packets:1311 errors:0 dropped:0 overruns:0 frame:0
> TX packets:1937 errors:0 dropped:0 overruns:0 carrier:0
> collisions:0 txqueuelen:1000
> RX bytes:191173 (191.1 KB) TX bytes:249297 (249.2 KB)
> How can I use 10 Gb SFP port1? Any advice would be appreciated.
My guess is that you have a problem with your cabling, or the SFP+
module that you plugged in to the USRP.
What SFP+ module are you using? What type of wiring/optical?
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the USRP-users