[USRP-users] RFNOC_OOT_SRCS cleared in top/n3xx/Makefile.srcs

Andrew Payne wandrewp at gmail.com
Thu Jan 30 16:15:18 EST 2020


Not to change the original intent of this question: 1. What’s the
recommended combination (versions) of UHD and Gnuradio? 2. Do you recommend
pybombs (I installed from source which was slightly painful but now that I
got the dependencies should be smoother if I do it again).

On Thu, Jan 30, 2020 at 15:57 EJ Kreinar <ejkreinar at gmail.com> wrote:

> Whoa there,
>
> I havent updated any of my code to UHD-3.15 yet so you're a bit ahead of
> me! I usually make the relevant PRs if/when OOT build process breaks -- so
> I'd recommend sending over the relevant PR to fpga repo? Will probably help
> me a few months down the line :P
>
> Thanks!
> EJ
>
> On Wed, Jan 29, 2020 at 5:28 PM Andrew Payne via USRP-users <
> usrp-users at lists.ettus.com> wrote:
>
>> I had the same issues! I just ended up putting my verilog file paths in
>> Makefile.n3xx.inc and it works. This might need to be fixed unless I did
>> something wrong.
>>
>> On Wed, Jan 29, 2020 at 16:18 Rob Kossler via USRP-users <
>> usrp-users at lists.ettus.com> wrote:
>>
>>> I have been struggling all day with why I can't build my OOT rfnoc
>>> blocks for the N310 using v3.15.0.0.  It appears that the problem is that
>>> there is a file top/n3xx/Makefile.srcs that is clearing the RFNOC_OOT_SRCS
>>> variable after it is set in the users OOT makefile. I just commented the
>>> line in top/n3xx/Makefile.srcs and that seems to do the trick.  Is this a
>>> known issue?
>>>
>>>
>>> # Makefile.n3xx.inc
>>> ...
>>> include $(BASE_DIR)/n3xx/Makefile.OOT.inc
>>> include $(BASE_DIR)/n3xx/Makefile.srcs
>>> ...
>>>
>>> # Makefile.srcs
>>> RFNOC_OOT_SRCS = \
>>> _______________________________________________
>>> USRP-users mailing list
>>> USRP-users at lists.ettus.com
>>> http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
>>>
>> _______________________________________________
>> USRP-users mailing list
>> USRP-users at lists.ettus.com
>> http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
>>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.ettus.com/pipermail/usrp-users_lists.ettus.com/attachments/20200130/c50b1aa0/attachment.html>


More information about the USRP-users mailing list