[USRP-users] X310 unable to connect after recovery procedure

Joe Martin k5so at k5so.com
Fri Mar 22 13:52:02 EDT 2019


Nicolas, 

It appears you were pinging 192.168.10.3, not 192.168.10.2.  Maybe this particular example was simply a typo and you used the correct IP address to ping during your other tests?

Regards, 

Joe

> On Mar 22, 2019, at 11:05 AM, Nicolas GALLAND via USRP-users <usrp-users at lists.ettus.com> wrote:
> 
> Hello everyone,
> 
> I had some trouble with my X310 and I needed to upload my UHD installation and consequently to update the FPGA image on the board. After doing it through eternet port, I lost connection so I decide to follow the recovery procedure to upload the FPGA image using the JTAG port (following https://kb.ettus.com/X300/X310_Device_Recovery).
> 
> The upload is fine, and the computer recognises the network with IP address 192.168.10.1, but when I try to ping 192.168.10.2 (as explained in the procedure) I have
> 
> PING 192.168.10.3 (192.168.10.3) 56(84) bytes of data.
> From 192.168.10.1 icmp_seq=1 Destination Host Unreachable
> From 192.168.10.1 icmp_seq=2 Destination Host Unreachable
> From 192.168.10.1 icmp_seq=3 Destination Host Unreachable
> From 192.168.10.1 icmp_seq=4 Destination Host Unreachable
> From 192.168.10.1 icmp_seq=5 Destination Host Unreachable
> 
> until I stop it. I have two x310 in the same situation, and I tried on two different computers with different ethernet cables.
> 
> Could the hardware be broken ? (If so, isn't it strange that the computer still sees the network ?)
> 
> Thanks a lot, and nice week end !
> 
> Kind regards,
> 
>     Nicolas
> 




More information about the USRP-users mailing list