[USRP-users] X310 unable to connect after recovery procedure

Nicolas GALLAND nicolas.galland at obspm.fr
Fri Mar 22 13:05:15 EDT 2019


Hello everyone,

I had some trouble with my X310 and I needed to upload my UHD 
installation and consequently to update the FPGA image on the board. 
After doing it through eternet port, I lost connection so I decide to 
follow the recovery procedure to upload the FPGA image using the JTAG 
port (following https://kb.ettus.com/X300/X310_Device_Recovery).

The upload is fine, and the computer recognises the network with IP 
address 192.168.10.1, but when I try to ping 192.168.10.2 (as explained 
in the procedure) I have

PING 192.168.10.3 (192.168.10.3) 56(84) bytes of data.
 From 192.168.10.1 icmp_seq=1 Destination Host Unreachable
 From 192.168.10.1 icmp_seq=2 Destination Host Unreachable
 From 192.168.10.1 icmp_seq=3 Destination Host Unreachable
 From 192.168.10.1 icmp_seq=4 Destination Host Unreachable
 From 192.168.10.1 icmp_seq=5 Destination Host Unreachable

until I stop it. I have two x310 in the same situation, and I tried on 
two different computers with different ethernet cables.

Could the hardware be broken ? (If so, isn't it strange that the 
computer still sees the network ?)

Thanks a lot, and nice week end !

Kind regards,

     Nicolas




More information about the USRP-users mailing list