[USRP-users] Phase after Freq Hopping

Patscheider, Dominik dominik.patscheider at student.kit.edu
Mon Mar 18 06:29:59 EDT 2019


Hey,

What I wanted to achieve is a stepped OFDM Radar. 
To increase the baseband for the radar, I´m splitting the subcarrier and transmit them on four center frequencies. 
Thus it sends the first symbols on f0 (with an initial phase); afterwards increasing the center freq to f1 and transmit the next symbols,...
And obviously the initial phase is changing after reconfiguring the frequency. If phase1, phase5, phase9,... phase2,phase6,... isn´t the same, it´s not possible to measure any velocity.

Secondly, the time commands to change the freq I knew but didn´t use right now.

Hope this explanation was useful to understand me and thanks for helping :)

Dominik

-----Ursprüngliche Nachricht-----
Von: USRP-users <usrp-users-bounces at lists.ettus.com> Im Auftrag von Piotr Krysik via USRP-users
Gesendet: Freitag, 15. März 2019 14:52
An: usrp-users at lists.ettus.com
Betreff: Re: [USRP-users] Phase after Freq Hopping

W dniu 12.03.2019 o 17:49, Patscheider, Dominik via USRP-users pisze:
>
> Hello ,
>
>  
>
> For a Radar I´m transmitting and receiving with the USRP X310 samples 
> on different frequency steps.
>
>  
>
> For instance, after 4 frames I´m coming back to the first center freq 
> and continue this a few times. Hope the following description helps…
>
>  
>
> f3                   |phase4|       |…|
>
> f2                  |phase3|       |…|
>
> f1               |phase2|       |phase6|       …
>
> f0            |phase1|       |phase5|
>
>                 t ------>
>
> According to the freq adjust every frame starts with a new phase.
>
> Phase 1 ≠Phase 5
>
>  
>
> Is there any possibility to get the same phase after returning to the 
> same center freq? Phase 1=Phase 5, Phase 2 = Phase 6,…
>
>  
>
>
Hi Dominik,

Can you describe what you want to achieve exactly? Probably you need to know phase relations because you want to do coherent processing of the signal. But from your description I don't know:
-why on your ASCII art the signals transmitted on different frequencies seems to be overlapped?
-which you part of it you want to process coherently?

I also often use USRPs for radar transmissions. Issues with predicting initial phase difference of the received signal, in relation to digital waveform that is being transmitted, are much easier to overcome when you use timed commands to set the frequencies on Rx and Tx side synchronously (if you use UBX or SBX daughter-boards).

Best Regards,
Piotr Krysik


_______________________________________________
USRP-users mailing list
USRP-users at lists.ettus.com
http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com


More information about the USRP-users mailing list