[USRP-users] USRP x310 with multi_usrp and RFNoC
martin.braun at ettus.com
Fri Feb 22 18:19:24 EST 2019
This pokes a register in the STC3. It'll pull the FPGA into reset. You then
need to wait a bit before the FPGA is back up.
On Fri, Feb 22, 2019 at 10:21 AM Brian Padalino via USRP-users <
usrp-users at lists.ettus.com> wrote:
> On Wed, Feb 20, 2019 at 7:45 PM Jonathon Pendlum <
> jonathon.pendlum at ettus.com> wrote:
>> Hi Armin,
>> You can reset X3x0 series devices via a register write with the following
>> command (this is in to your UHD src directory):
>> firmware/usrp3/x300/x300_debug.py --addr 192.168.40.2 --poke=0x00100058
> Can you elaborate a little bit on what this register does, and why the UHD
> software might not always poke it to reset it?
> USRP-users mailing list
> USRP-users at lists.ettus.com
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the USRP-users