[USRP-users] Configuration of E310 USRP

nauman.iqbal at surrey.ac.uk nauman.iqbal at surrey.ac.uk
Mon Jul 31 11:14:38 EDT 2017

Yes, You are right I am using X310.  Thankyou for your quick response.


From: Derek Kozel [mailto:derek.kozel at ettus.com]
Sent: 31 July 2017 16:10
To: Iqbal N Mr (Elec Electronic Eng) <nauman.iqbal at surrey.ac.uk>
Cc: usrp-users at lists.ettus.com
Subject: Re: [USRP-users] Configuration of E310 USRP

Hello Nauman,
I assume that you are using the X310 rather than the E310.
It is not possible by default to use PCIe for configuration and control and then to use the SFP+ connections with Aurora for the sample streaming. The hardware could technically support such a configuration, but it would require extensive FPGA and host code development. I do not have a lot of familiarity with LabVIEW FPGA based workflows, but I would suggest looking into that as it is not impossible that that software stack could be made to support this.
The base UHD and regular LabVIEW NI-USRP drivers do not support that set of configurations.

On Mon, Jul 31, 2017 at 2:22 PM, Nauman Iqbal via USRP-users <usrp-users at lists.ettus.com<mailto:usrp-users at lists.ettus.com>> wrote:
      I am looking at the UHD’s initialization of radio parameters. Is there a possibility if we can use the PCIe interface and Labview comms to configure the radios and at same time configure the streamers to be using 10gig Ethernet to send/receive baseband streams? So the configuration is done totally independently via PCIe and a labiew GUI, plus we want to use Aurora instead of the 10G Ethernet for the streamers.



USRP-users mailing list
USRP-users at lists.ettus.com<mailto:USRP-users at lists.ettus.com>

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.ettus.com/pipermail/usrp-users_lists.ettus.com/attachments/20170731/3e79814b/attachment-0002.html>

More information about the USRP-users mailing list