[USRP-users] about 10 Gig ethernet configuration

Neel Pandeya neel.pandeya at ettus.com
Mon Oct 19 15:51:18 EDT 2015


Hello Sanjoy:

That Intel X520 10GbE card with Ubuntu 14.04.3 should be working well for
you.

Could you try upgrading to kernel 3.16 or 3.19, and let us know your
results?

To upgrade to kernel 3.16, run "sudo apt-get install
linux-generic-lts-utopic".

To upgrade to kernel 3.19, run "sudo apt-get install linux-generic-lts-vivid
".

After the upgrade, be sure to reboot the system.

Also, check that you have the CPU governors set to "performance", and that
you have the highest clock rate set.

--Neel



On 19 October 2015 at 12:03, Sanjoy Basak via USRP-users <
usrp-users at lists.ettus.com> wrote:

> Hi Experts,
> We recently bought a 10 Gig ethernet card (X510-DA2) and Twinaxial-Kabel
> SFP+ M SFP+ M 3,0m. I installed it in our pc (OS: Ubuntu Mate 14.04.3 LTS)
> and can communicate with X310/SBX-120 properly. However, the performance we
> are getting is quite poor. I am getting dropped packets (D O) mostly at
> 25,50 MSps and goes quite crazy at 100 MSps and sometimes even at lower
> sample rates.
> Previously I tested with 1 Gig ethernet, at 25 MSps I could stream without
> any drop/late packet or underrun.
> The CPU uses or network uses is also not reaching 100%.
>
> Could you please tell me what to check/correct so I can stream at 100 MSps
> without any error?
>
> I am putting the ifconfig and ethtool results and the kernel version(
> 3.16.0-30-generic)
>
> eth2      Link encap:Ethernet  HWaddr 90:e2:ba:a6:a9:dd
>           inet6 addr: fe80::92e2:baff:fea6:a9dd/64 Scope:Link
>           UP BROADCAST MULTICAST  MTU:9000  Metric:1
>           RX packets:4530726 errors:146 dropped:0 overruns:0 frame:146
>           TX packets:6811057 errors:0 dropped:0 overruns:0 carrier:0
>           collisions:0 txqueuelen:1000
>           RX bytes:26331306938 (26.3 GB)  TX bytes:35856233935 (35.8 GB)
>
> Settings for eth2:
> Supported ports: [ FIBRE ]
> Supported link modes:   10000baseT/Full
> Supported pause frame use: No
> Supports auto-negotiation: No
> Advertised link modes:  10000baseT/Full
> Advertised pause frame use: No
> Advertised auto-negotiation: No
> Speed: 10000Mb/s
> Duplex: Full
> Port: Other
> PHYAD: 0
> Transceiver: external
> Auto-negotiation: off
> Cannot get wake-on-lan settings: Operation not permitted
> Current message level: 0x00000007 (7)
>       drv probe link
> Link detected: yes
>
> Our computer config is:
> Processor: 12*Intel(R) Xeon (R) CPU E5-2620 v3 @2.40 GHz
> RAM: 65871 MB
> SSD raid 5
>
>
> Best regards
> Sanjoy
>
> _______________________________________________
> USRP-users mailing list
> USRP-users at lists.ettus.com
> http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.ettus.com/pipermail/usrp-users_lists.ettus.com/attachments/20151019/d74c6427/attachment-0002.html>


More information about the USRP-users mailing list