[USRP-users] ERROR: USRP E310 Network mode
zhangxinke at iie.ac.cn
Wed Apr 15 21:34:19 EDT 2015
I used the e310 sdk toolchain to build the uhd source codes in the host pc, and then transfer the built binary to the e310 device. However, i need to copy the seperate built binary into its corresponding directory. is there any automatic solution to update the uhd in the e310 device? Thanks.
> -----Original Messages-----
> From: "Moritz Fischer" <moritz.fischer at ettus.com>
> Sent Time: Thursday, April 16, 2015
> To: "Xinke Zhang" <zhangxinke at iie.ac.cn>
> Cc: "usrp-users at lists.ettus.com" <usrp-users at lists.ettus.com>
> Subject: Re: [USRP-users] ERROR: USRP E310 Network mode
> Hi Xinke,
> When upgrading your device UHD you also need to upgrade your host UHD.
> The current dizzy-test images are build from the 3.8.3-RC1 tag. Make
> sure you build off of that.
> Also note that you'll need to run uhd_images_downloader to get the
> correct fpga image in place on the device.
> On Tue, Apr 14, 2015 at 9:44 PM, Xinke Zhang via USRP-users
> <usrp-users at lists.ettus.com> wrote:
> > Hi,
> > I'm using the usrp e310, and reburn the sd card with
> > http://files.ettus.com/e3xx_images/beta/dizzy-test/sdimage-gnuradio-demo.direct.xz.
> > when configuring the usrp e310 as network mode (config the ip addr and start
> > the usrp_e3x0_network_mode), i use the uhd_find_devices and i can find the
> > usrp e310 devices, but when i use the uhd_usrp_probe, it came out the error
> > message "Error: e300_remote_codec_ctrl_impl trancation failed". Pls help
> > check it. Thank you in advance.
> > the version of uhd installed in the host pc is 3.8.2-151-gbf4f50de.
> > Best Regards,
> > Xinke
> > _______________________________________________
> > USRP-users mailing list
> > USRP-users at lists.ettus.com
> > http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the USRP-users