[USRP-users] NEED ALL THE HELP I CAN GET

Vlad Stoianovici stoianovici_vlad at yahoo.com
Tue Nov 30 18:44:38 EST 2010


Did you load the appropriate USRP2 binaries (UDP for your particular daughterboard) from http://code.ettus.com/redmine/ettus/projects/public/wiki/U2binaries ?
If you didn't load the FPGA and firmware images it will never work.
Check if you have a gfunctional cable connection and that your network card supports Gigabit connections!  

Vlad.


--- On Wed, 12/1/10, Feven Worku <feven at student.chalmers.se> wrote:

From: Feven Worku <feven at student.chalmers.se>
Subject: [USRP-users] NEED ALL THE HELP I CAN GET
To: "USRP-users at lists.ettus.com" <USRP-users at lists.ettus.com>
Date: Wednesday, December 1, 2010, 12:54 AM

Hello Everyone? I am doing a project on USRP2 using matlab simulink 2010. But i am stacked somewhere that is i configure my PC static ip to 192.168.10.1 and subnet 255.255.255.0 and the USRP 2 on matlab simulink ip address to 192.168.10.255 and after this i try to run the simulink demo commusrp2. But i keep on getting the two  errors 'Embedded MATLAB Runtime Error: Board did not reply to a host query or configuration. Cannot run simulation. Please ensure you have a connection by opening the block mask and examining the Hardware section.'‘Error reported by S-Function 'sdspToNetwork' in 'commusrp2/USRP2 Receiver/Terminate data stream': Network is unreachable’  Can i get any help from anyone of u?

  Feven
-----Inline Attachment Follows-----

_______________________________________________
USRP-users mailing list
USRP-users at lists.ettus.com
http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com



      
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.ettus.com/pipermail/usrp-users_lists.ettus.com/attachments/20101130/72312ddd/attachment-0002.html>


More information about the USRP-users mailing list